A check engine light, also called the engine management light, means the car’s computer has stored a fault in the engine, fuel, ignition or emissions systems. Steady amber: the car is telling you to get it read soon, and most are fine to drive carefully to a garage. Flashing, or red: slow down and stop somewhere safe, because the fault can be serious. Your handbook has the final say on your model; this guide covers the common patterns and what the law and the MOT do with the light.
It also matters if you’re buying. A light that comes on, or one that has been disconnected so it never does, is a fault the previous keeper has handed to you.
What do the colours of the engine light mean?
Dashboards differ between makers, so treat this as the usual pattern and check the handbook symbol page for your car.
| What you see | Usual meaning | What to do |
|---|---|---|
| Amber, steady | A fault is stored; the car has usually adjusted how it runs | Book a diagnostic read within days; drive gently until then |
| Amber, flashing | Often a misfire, where fuel is not burning properly | Ease off the throttle and stop driving it hard; get it looked at the same day if you can |
| Red | A serious fault or a warning that can cause damage, such as overheating or low oil pressure | Stop safely and switch off; don’t keep driving to see what happens |
| Light on, then off after a few seconds at start-up | The normal bulb check | Nothing |
The oil-can and coolant-temperature symbols are separate lights. If one of those is red, stop the same way, whatever the engine symbol is doing.
Is it safe to drive with the check engine light on?
Often, for a short time, and if it’s steady and the car drives normally. Don’t carry on if any of these happen: the light flashes, the engine shudders or loses power, there’s a burning or fuel smell, smoke, or a temperature or oil light joins it.
A misfire is the one to respect. Unburnt fuel can reach the catalytic converter and overheat it, which turns a cheap fault, such as a worn spark plug, into an expensive one. Driving a long way with the light on can also hide a second fault that turns up behind the first.
What are the most common causes?
The light is a symptom, and the stored code points to the cause. These are the ones garages see most often:
- A loose or damaged fuel cap. It lets fuel vapour escape and can trigger an evaporative emissions code. Tighten it until it clicks and see whether the light clears after a few drives.
- An oxygen (lambda) sensor. It measures what leaves the exhaust and lets the engine adjust the mixture. When one fails, economy drops.
- Spark plugs or ignition coils. Worn ones cause misfires, rough running and hesitation.
- The mass airflow sensor. A dirty or faulty one upsets the fuel mixture.
- The catalytic converter. Often the result of another fault left too long, but it can also wear out on its own.
- The EGR valve or the diesel particulate filter. Short trips are hard on both, because they never reach the temperature needed to clear soot.
None of these is a diagnosis. Two cars with the same symptoms can have different causes, which is why you read the code before you buy a part.
How do I find out what the fault is?
- Check the basics: the fuel cap, and whether the light came on straight after fuelling.
- Plug a code reader into the diagnostic port, usually under the dashboard on the driver’s side. Basic readers are on sale from motor shops; garages have better ones.
- Write down the code (a letter followed by four digits) and any freeze-frame data the tool shows.
- Look the code up for your engine, or ask a garage to confirm it before parts are changed.
- After the repair, clear the code and drive normally. A light that returns means the cause wasn’t fixed.
Don’t clear the code just to switch the light off before a sale or an MOT. The system keeps readiness monitors that show a recent reset, and the fault is still there.
Will a check engine light fail the MOT?
Yes, on the cars where the test applies. Open the DVSA’s MOT manual on GOV.UK (page opened 20 Nov 2026) and you’ll find “engine MIL inoperative or indicating a malfunction” graded as a major defect. A major defect is a fail. The tester turns the ignition on and watches the light: it should come on, and go out once the engine is running on cars where that applies.
The manual applies the check to petrol cars, hybrids included, that came into use from 1 July 2003, and to diesels, hybrids included, from 1 July 2008. Kit cars, amateur-built vehicles and American pickups are listed as exempt. Both outcomes are failures: a light that stays on and a light that never comes on at all, which suggests the bulb was removed.
Other warning lights have their own entries in the manual: the ABS light under brakes, the airbag light under other equipment, and the tyre pressure monitoring light with axles, wheels, tyres and suspension. The full guidance is at the DVSA manual for cars and light vans on GOV.UK.
Can I see past check engine light problems in a car’s history?
Partly. The light itself isn’t recorded anywhere, but an MOT failure for it is. Every MOT result sits in the DVSA’s archive, with the date, the mileage and the reason for failure. Run the MOT history check on a car you’re considering and look for a failure on the engine light or on emissions that was followed by a pass.
Two patterns are worth asking about. The first is a fail for the light, a gap of weeks, then a pass at a different test centre. The second is repeated emissions advisories or failures across several years. Both can mean an unresolved fault.
The free vehicle check shows the MOT trail. The full report adds the records an MOT doesn’t hold, such as finance and write-off history, so a car with a persistent engine fault is also checked for what sits behind it. See what each section covers on the what we check page.
What about hybrids and electric cars?
A hybrid has an engine, so it has the same engine light and the same MOT rule. The same DVSA manual applies the ignition-on check to petrol and diesel hybrids as well as conventional cars, using the same dates. A hybrid can also show a separate warning for its battery or electric system, with its own symbol in the handbook. Treat a red hybrid system warning like any red light: stop safely and call for help.
A fully electric car has no engine, so no engine management light. It has warnings for the battery, the motor and the charging system, and the maker’s handbook is the guide to those.
What should I ask a seller about the engine light?
- Does the light come on at start-up and go out? Watch it happen with the key turned, before the engine runs.
- Has it ever lit up, and what was the code? Ask for the garage invoice.
- Was the car recently serviced, and when were the spark plugs, filters and sensors last done? The used car warranty guide explains what cover may exist if a fault appears later.
- Can you plug in a code reader before you buy? A seller who says no has told you something.
Pair the answers with a proper test drive, from cold, with the radio off.
Related checks and guides
A warning light is only one record in a car’s story. The MOT history check shows whether the same fault was flagged before, the mileage check shows how the car has been used, and the guide to reading a history report ties them together. The prices page lists what the full check adds.
Questions
What does the check engine light mean?
The engine control unit has logged a fault in the engine, fuel, ignition or emissions systems. The stored code, read with a diagnostic tool, tells you which.
Is the engine management light the same as the check engine light?
Yes. Different makers and regions use different names for the same warning, and the MOT manual calls it the malfunction indicator lamp, or MIL.
Why is my check engine light flashing?
A flashing light often signals a misfire, where fuel isn’t burning in a cylinder. Reduce speed and load, and have it checked the same day, as continuing can damage the catalytic converter.
Can I drive with the check engine light on?
If it is steady and the car feels normal, a short careful drive to a garage is usual. If it flashes, the car loses power or you see smoke, stop.
Will the light go off by itself?
It may, if the fault was temporary, such as a loose fuel cap. If it comes back, the fault is real and needs reading.
Does the check engine light fail an MOT?
For petrol cars used from 1 July 2003 and diesels from 1 July 2008, a light signalling a malfunction counts as a major defect, so the car fails.
How much does it cost to fix?
It depends entirely on the cause. A fuel cap costs little; a catalytic converter doesn’t. Get the code read first, then a written quote.
Should I buy a car with the engine light on?
Only if the seller has the code read and quoted, and you price the repair into your offer. If they refuse to let you check, walk away.